Swim pro sand filter hook up

swim pro sand filter hook up

How do I connect my sand filter to my pool pump?

There are 3 hoses for you to connect when installing your sand filter. The first hose connects from the thru-wall skimmer on the pool to the front of the pump, also known as the strainer housing. On the skimmer there should be a fitting where the hose will connect.

How high should a pool sand filter be installed?

The pool filter should be installed on a level concrete slab not more than 6 feet above the pool water level. Position the pool sand filter so that the piping connections, multiport valve and drain are convenient and accessible for operation and maintenance.

How many hoses do I need to install a sand filter?

There are 3 hoses for you to connect when installing your sand filter. The first hose connects from the thru-wall skimmer on the pool to the front of the pump, also known as the strainer housing.

What kind of sand filter does Aquapro use?

The AquaPro 19″ master series is a high-rate sand filter that offers leading edge technology for unparalleled efficiency, flow and serviceability. The 7-way valve provides simple operation and dependability.

How do you hook up a sand filter to a pool?

Correctly hook up your sand filter and pump to your above-ground pool for hours of summer fun. Place the sand filter close to the pump. Make sure to locate it near the skimmer and return on your pool.

How to install a pool pump and filter?

Place the pump and filter assembly on level ground next to the electric source. Make sure the pool filter and pump are on level ground because if the ground is not level, the filter assembly will vibrate. Too much vibration may loosen some of the internal parts of the filtration system and cause damage. Connect the pump to the filter housing.

How do you connect a pool pump to a pool hose?

Connect the pump to the filter housing. Apply plumbers tape at the point of connection to prevent leaking. Attach the hose from the filters out spout to the pools return port. If the hose is the screw-on type, apply plumbers tape at the connection points just as you did when connecting the filter housing and the pump.

How many hoses do I need to install a sand filter?

There are 3 hoses for you to connect when installing your sand filter. The first hose connects from the thru-wall skimmer on the pool to the front of the pump, also known as the strainer housing.

Why choose a Aquapro sand pump and filter system?

AquaPro’s sand pump and filter system for above ground pools offers leading edge technology for unparalleled efficiency, flow and serviceability. The 7-way operating valve provides simple operation and dependability.

Which is the best sand filter for above ground pool?

Sand Filters for Above Ground Pools - Aquapro Systems Sand Filters for Above Ground Pools AquaPro series of high-rate sand filters offers leading edge technology for unparalleled efficiency, flow & serviceability. The seven position operating valve provides simple operation and dependability.

How much water does a sand filter turn over?

Most Sand Filters turn over approximately 2400 gallons per hour. It is recommended that you turn over the water in your pool at least twice a day (refer to chart at bottom of page for your pools capacity). Run filter more in hot weather or with heavy bather load.

How do you backwash a sand filter?

Always backwash the filter immediately after adding new sand to the filter. Before plugging in filter, turn valve handle (located on top of filter) to the backwash setting.

Related posts: