How do you hook up a cb antenna

how do you hook up a cb antenna

How to install a CB radio antenna?

To complete your antenna installation, you need to do a CB radio setup, and the logical first step is to use an SWR meter. An SWR meter, whether built-in or in a separate unit, will also help you determine where to mount your antenna.

How to connect a CB microphone to a car radio?

Simply put, you are going to have to connect your coax to the antenna by running the CB coax cable all the way from the antenna to the radio. The next task is to connect your CB mic. After this is done, you have to power the radio. Powering the radio can be done in a few ways.

How do you mount an antenna to a coaxial cable?

A magnetic mount just sets on the roof. A door jamb mount requires measuring and drilling and adjustments to get the antenna vertical. Follow the instructions for installing your mount as closely as possible (if it came with any). Also, make sure that you have all of the proper components to attach your antenna mount to the coax.

How long does it take to make a base station antenna?

This is a simple base station CB antenna You can make in 30 minutes out of a bit of PVC pipe and fittings, some wire and a SO239 coax connector and a piece of coax to connect it to your radio. You should have a 1.5 SWR on this.

Can You mount a CB radio on an antenna?

Both single mounts (for CB radios only) and double mounts (for AM/FM radios as well as CB radios) are available. Also, a lot of people seem to like the hump mounts. After youve installed your CB radio, its time to add the antenna to the system.

What should I do after Ive installed my CB radio?

After youve installed your CB radio, its time to add the antenna to the system. IMPORTANT: Do not key your mic before the antenna is installed! If you do, you risk damaging or destroying your radio! Youll find a great selection of antennas on our mobile antennas page.

How to wire a CB radio?

Now, how to wire a CB radio - that means that youll need to run your coaxial cable from the antenna to the CB radio plus provide a source of power to run the radio. How youll do that depends on your vehicle. You may need to run cable from the trunk lid through the back seat, then under the doorframe and window pillar or the dash and firewall.

How do you tune a CB antenna?

Tune it every time you move the antenna, add a spring or quick disconnect, modify your vehicle with a large metal component, hit your antenna on something, change your coax length, switch to a different mount, and more. You can find a link to an article on CB antenna tuning here.

How long does it take to make a CB antenna?

More About rbodell » This is a simple base station CB antenna You can make in 30 minutes out of a bit of PVC pipe and fittings, some wire and a SO239 coax connector and a piece of coax to connect it to your radio. You should have a 1.5 SWR on this.

How does a CB station base antenna work?

The primary work of a CB station base antenna is to capture the radio signals and transmit them to your radio receiver, where theyre converted to electrical signals. It also takes the electric signals from your receiver and converts them into radio signals for transmission to other CB radios that are miles away from you.

How long should a base antenna be?

They are normally 4-6 in length and greatly improve the performance of your base station antenna. If youre looking for something thats not 18-feet tall and needs to be installed outside, the Firestik IBA serves as an excellent base antenna for emergency use.

Can you use any CB radio in a base station setup?

To save on cost, you can use any mobile CB radio in your base station setup if you add a power supply to your system. A 5-amp power supply works great for powering a 12-volt CB radio. You can pair this power supply with any mobile CB radio, including popular models such as the Cobra 29 LTD, President McKinley SSB, and the Galaxy 959 SSB.

Related posts: