Shower drain hook up

shower drain hook up

How do you install a plastic shower drain?

Use plastic drain pipe and fittings, either PVC or ABS, for the new shower drain. Turn off the water lines to the area youll be working on. Locate the existing drain, and determine the spot where you want to connect the new shower drain.

How do I connect a shower to a plumbing vent?

Connect the shower drain to a plumbing vent. Depending on local plumbing codes, the vent will usually need to connect to the shower drain within 42 inches of the shower.

Do I need an elevated shower drain?

Shower Elevation. To allow adequate drainage from the shower to an up-flush system, the shower must be elevated. The standard slope required on a water drainage pipe is 1/4 inch per linear foot of pipe. Creating room for the drain slope, as well as for a P-trap installed in the drain line beneath the shower, necessitates using an elevated shower...

What size pipe do you use for a shower drain?

Because most shower drains are 2-inch drains, look for an existing pipe that is 2 inches or larger in diameter to connect the new shower drain. Use plastic drain pipe and fittings, either PVC or ABS, for the new shower drain.

How to install a PVC drain in a shower?

Strategically place the PVC drain body such that the bottom part is inside the hole while at the same time the drain is being supported by the shower floor. Apply the PVC prep and let it rest for 20 seconds before applying the PVC cement on the current plumbing and the new shower drain. Use PVC glue to attach the drain cap onto the shower floor.

How do you install a shower liner on a wall?

Use troweled mortar to create the solid underlayment for the shower, sloping it 1/4 per foot from the walls toward the drain. The liner is then installed over the floor and flange of the shower pan. Use silicone caulk to seal the liner to the drain flange. Trim away the liner around the drain opening.

How do you install a rubber shower base?

Put the shower base into place and push the rubber gasket into the drain pipe. You may need to use a screwdriver to push this into place, as they are designed to fit tightly. Normally these shower drains come with a tool to help you tighten the nut from inside of the drain. Tighten the nut with this tool.

How do you attach a strainer to a shower liner?

Trim away the liner around the drain opening. Insert the middle flange of the drain fitting over the liner and drain opening, using bolts to secure it to the bottom flange beneath the liner. Attach the drain strainer assembly to the drain, so it stands up from the liner about 1 1/2 inches.

Do you need a larger pipe for a shower drain?

It is imperative to use a larger shower drain pipe size to keep the water flowing into your pipes instead of onto the surrounding floor. What is the standard size pipe for a shower drain then?

Is a 2 inch shower drain better than 1 inch?

Honestly speaking, a 2-inch shower drain is slightly better than the 1 1 2 inches for draining water effectively. But at the same time, some building codes don’t allow you to fix 2-inch pipe but approve to use 1 ½ inch pipe. Does A Shower Drain Need a Vent Pipe? To clean out the shower water, a vent pipe is required.

What size pipe do I need for a shower tray?

If your building code only requires a 1.5-inch drain pipe size and you do not want to go with the two-inch that most shower trays are built to accommodate, you still have other options. Some plumbing experts will tell you that you can simply reduce the pipe size.

What kind of pipe do you use for a compression drain?

Compression drains come in PVC, ABS, or brass pipe. Any of these can be used with steel, fiberglass, or plastic shower bases. When installing a compression shower drain, the drain fitting is first installed into the shower base. The drainpipe should come up to about 3/4 to 1 inch below the lip of the shower drain.

Related posts: